Initial Configuration Of An E1/T1 Card Through The Command Line Interface - Avaya Communication Server 1000 Installation And Commissioning Manual

FTP
You can access the E1/T1 card remotely by FTP for the file transfer. The FTP logon and
password are the same as those defined for Telnet. After you log on, standard FTP commands
apply.
Initial configuration of an E1/T1 card through the command line
interface
Follow the steps in
configuration, you carry out all configuration, administration and maintenance through the
Web-based interface.
Configuring basic LAN parameters by CLI
1. Connect the RS-232 serial port (D-type 9 pins) to a terminal or a PC with terminal
2. Configure the interface to:
3. Make sure that flow control is none.
CLI over a Web-based interface
You can access the CLI through the administrative console, which is useful if a firewall does
not allow Telnet access. See
page 109.
Accessing the command line interface over the Web
1. To open a CLI screen, access the administration console and click CLI on the toolbar
2. Enter commands and text as needed.
Media Gateway 1000E PRI Gateway Installation and Commissioning
Configuring basic LAN parameters by CLI
emulation (for example, HyperTerminal).
• 9600 baud
• 8 data bits
• 1 stop bit
• no parity
Accessing the command line interface over the Web
at the top of the screen.
A separate window opens.
Initial configuration of the E1/T1 card
on page 109. After the initial
March 2013
on
109