Table of Contents
Advertisement
11-911 Bin 1 Full Stack RAP
The Control Logic detected that Bin 1 is full.
Initial Actions
•
Refer to BSD12.9 for the following procedure.
•
Ensure that Bin 1 is empty
Procedure
Enter dC330 012-281 Bin 1 Full Sensor. Press Start. Manually move the actuator in and out of
the sensor The display Changes from H to L to H as the actuator is moved in and out of
the sensor.
Y
N
Press Stop. +5VDC is measured between P/J1002-1 and DC COM on the Mailbox
PWB.
Y
N
+5VDC is measured between P/J1031-11 and DC COM on the Finisher PWB.
Y
N
Replace the Finisher PWB
Go to
Flag 1
on BSD12.9 and check the wires for an open circuit.
Replace the Mailbox PWB
(PL
18.11).
Check the Bin 1 Full Sensor for intermittent operation. If the problem continues, replace the
Mailbox PWB
(PL
18.11).
Reissue
DocuColor 12/DCCS50
(PL
18.4).
11-912 Bin 2 Full Stack RAP
The Control Logic detected that Bin 2 is full.
Initial Actions
•
Refer to BSD12.9 for the following procedure.
•
Ensure that Bin 2 is empty
Procedure
Enter dC330 012-282 Bin 2 Full Sensor. Press Start. Manually move the actuator in and out of
the sensor The display Changes from H to L to H as the actuator is moved in and out of
the sensor.
Y
N
Press Stop. +5VDC is measured between P/J1002-2 and DC COM on the Mailbox
PWB.
Y
N
+5VDC is measured between P/J1031-10 and DC COM on the Finisher PWB.
Y
N
Replace the Finisher PWB
Go to
Flag 2
on BSD12.9 and check the wires for an open circuit.
Replace the Mailbox PWB
(PL
Check the Bin 2 Full Sensor for intermittent operation. If the problem continues, replace the
Mailbox PWB
(PL
18.11).
1/05
11-911 Bin 1 Full Stack RAP, 11-912 Bin 2 Full Stack
8d-27
(PL
18.4).
18.11).
Finisher/Sorter
Advertisement
Table of Contents
Troubleshooting
