Hcf Feed Motor; Hcf Feeder Assembly - Xerox DocuColor 12/DCCS50 Service Manual

REP 2.8.26 HCF Feed Motor
Parts List on PL 15.16
Removal
To avoid electrical shock, switch-OFF the Main Power Switch and disconnect the Power
Cord.
1. Remove the HCF Paper Tray Assembly
2. Remove the HCF Rear Cover (PL 15.3)
3. Remove the HCF Feed Motor (Figure
2. Remove the Screws (4)
1. Disconnect
P/J-842
Figure 1 Removing the HCF Feed Motor
Replacement
NOTE: Do not over tension the Feed Belt. The tension produced by the weight of the motor is
sufficient.
1. Reverse the above procedures to replace the HCF Feed Motor.
2. Set the belt tension by loosening the four screws securing the Feed Motor and bias the
motor down to the bottom of the slots and tighten the four screws.
3. Loosen the screw securing the tensioning bracket and allow it to pivot into the drive belt.
Tighten the screw
Reissue
DocuColor 12/DCCS50
WARNING
(REP 2.7.5).
1).
3. Remove the Feed Motor
REP 2.8.27 HCF Feeder Assembly
Parts List on PL 15.10
Removal
To avoid electrical shock, switch-OFF the Main Power Switch and disconnect the Power
Cord.
1. Remove the HCF Paper Tray Assembly
2. Remove the HCF Rear Cover
3. Disconnect P/J 841 from the HCF Control PWB
4. Remove the 2 screws on the right side and 1 from the front of the HCF.
5. Remove the HCF Feeder Assembly
1. Remove the Feed Belt
Figure 1 Removing the HCF Feeder Assembly
Replacement
NOTE: Ensure that the Clutch and Locator Tab are engaged.
NOTE: Do not over tension the Feed Head Drive Belt. The tension produced by the spring is
sufficient.
1. Reverse the above procedures to replace the HCF Feeder Assembly.
2. Set the belt tension by loosening the four screws securing the Feed Motor and bias the
motor down to the bottom of the slots and tighten the four screws.
3. Loosen the screw securing the tensioning bracket and allow it to pivot into the drive belt.
Tighten the screw.
1/05
8a-21
WARNING
(REP 2.7.5).
(PL 15.10).
(PL 15.16).
(Figure 1).
2. Remove the Feeder Assembly
High Capacity Feeder
REP 2.8.26, REP 2.8.27