Hcf Brake - Xerox DocuColor 12/DCCS50 Service Manual

Short cable
Figure 5 Positioning the Cables in the correct position
2. Reconnect the Cable Ends to the Shaft refer to
NOTE: Position the Long Cable to the rear of the short cable on the two pulleys.
3. Manually rotate the drive shaft to check that the elevator plate raises and lowers evenly
and without interference.
Reissue
DocuColor 12/DCCS50
Cable guides
Long cable
(Figure 2).
REP 2.7.8 HCF Brake
Parts List on PL 15.3
Removal
To avoid electrical shock, switch-OFF the Main Power Switch and disconnect the Power
Cord.
1. Pull open the HCF Drawer.
2. Remove the HCF Brake (Figure
Remove the screws (2) while
holding Brake
Figure 1 Removing the HCF Brake
Replacement
1. Reverse the above procedures to replace the HCF Brake.
1/05
8a-19
WARNING
1).
High Capacity Feeder
REP 2.7.7, REP 2.7.8