Convenience Stapler Internal Dc Harness - Xerox DocuColor 12/DCCS50 Service Manual

REP 15-1 Convenience Stapler Internal DC Harness
Parts List on PL 16.1
Removal
1. Disconnect the Convenience Stapler Harness from the back of the Convenience Stapler.
2. Remove the bottom plate from the Convenience Stapler
3. Remove the Convenience Stapler Internal DC Harness
Figure 1 Remove the Plate
Reissue
DocuColor 12/DCCS50
(Figure 1).
(Figure 2).
1
Remove the screws (3).
2
Carefully separate the
bottom plate just enough
to access the connector
for the stapler.
3
Disconnect the stapler
connector from the
PWB.
Figure 2 Remove the Harness
Replacement
1. Install the new Convenience Stapler Internal DC Harness.
2. Reconnect the stapler connector to the PWB.
3. Reinstall the bottom plate.
4. Connect the Convenience Stapler Harness to the Convenience Stapler.
5. Check the operation of the Convenience Stapler by removing the Staple Cartridge and
closing the Convenience Stapler Cover. The red LED should be illuminated.
1/05
8b-7
1
Disconnect the
connectors.
2
Remove the harness
Convenience Stapler
REP 15-1