Table of Contents
Advertisement
The brake roller setting has been lost
The brake roller setting has been lost
Introduction
In the default setting, the brake roller is positioned parallel to the paper transport
infeed roller. The paper transport infeed roller is the metal roller that is located to the
upper right of the loop puller.
If the brake roller setting is lost
[104]
Proceed as follows:
1.
If the printing system has not yet stopped, click the 'Stop' button.
2.
Remove the inserted paper from the system by pressing and holding the
'Eject' button.
[236]
3.
[237]
4.
192
Chapter 6 Operating the printing system
Loosen the binding screw (A),
while holding the adjustment
knob (eccentric) (B) firmly
with the other hand.
Turn the adjustment knob (B) to
the left or right until the basic
setting is reached.
The basic setting is reached
when the thick line on the scale
is at the same level as the mark-
er groove.
Advertisement
Table of Contents
