Replacing the cleaning belt
Replacing the cleaning belt - overview
Introduction
The printing system detects the end of the cleaning belt's service life automatically
and displays a timely warning on the operator panel.
Caution:
During operation, the components in the fuser station reach a surface
temperature of approximately 230
burns. Do not touch any hot parts behind the safety covers (see
information signs on page
Wear heat protection gloves when working with fuser station components.
Overview
The following procedure is for replacing the cleaning belt:
Remove cleaning belt on page 414
Install cleaning belt on page 416
Replacing the cleaning belt - overview
o
C. Touching the components can cause
33).
Warning and
413