Table of Contents
Advertisement
Synchronization - Barcode synchronization mark for unperforated paper
[89]
[89] Vertical minimum and maximum values
B1
B2
Width of synchronization mark (C1, C2):
The width of the synchronization mark is always 10 mm.
The width cannot be changed.
Height of mark (D1, D2)
The height of the synchronization mark is always 48 mm.
The height cannot be changed.
Upper protected area (E1, E2)
The area of the PTL mark is used in both printing systems for the upper protected
area (sub-menu <Paper> <Sheets> <Mark type> = <Synchronization mark>
<Protected areas>.
The areas are the same (E1 = E2).
Lower protected area (F1, F2)
The area of the PTL mark is used in both printing systems for the lower protected
area (sub-menu <Paper> <Sheets> <Mark type> = <Synchronization mark>
<Protected areas>.
The areas are the same (F1 = F2).
Setting barcode synchronization marks in twin mode "duplex"
[90]
Position barcode synchronization mark
Printer 2
[207]
Synchronization mark printer 1 on the
back of the paper
Horizontal position of synchronization mark A1 in printing system 1:
The horizontal position of synchronization mark A1 in printing system 1 cannot
be changed. It is calculated using the set paper width and the width of the
synchronization mark. It is always on the right paper edge.
The value depends upon the value set in the sub-menu <Paper> <Paper width>.
168
Chapter 6 Operating the printing system
Minimum value
0
B1 + D1 + F1
Synchronization mark
printer 2
Maximum value
Page length - D1 - F1 - E2 - D2 - F2
Page length - 50.8 mm
Printer 1
Synchronization mark printer 1
[208]
Advertisement
Table of Contents
