Table of Contents
Advertisement
Proceed as follows:
[299]
3.
4.
Take the toner hose from the mounting on the toner supply unit and push to
the stop point on the developer station connecting pipe.
5.
Check whether all hoses are attached onto connecting pipes to stop.
[300]
6.
7.
Push in handle all the way.
[301]
8.
[302]
Caution
The door of the photoconductor drum should close easily. If not, the devel-
oper station has not been pushed fully into the printing system. In this case,
open the back door of the printing system and push the developer station
into the printing system up to the stop point.
Final tasks for installing the developer station
Push vacuum hose to the stop
point on the developer station
connecting pipe.
Hold the developer station by
the handle and push into the
printing system to the stop
point.
Place toner suction hose face
up.
235
Advertisement
Table of Contents
