Table of Contents
Advertisement
Removing the photoconductor drum
Removing the photoconductor drum
Caution:
Observe the safety directives in the section
drum - overview on page
Removing the photoconductor drum
[217]
Proceed as follows:
1.
If the printing system has not yet stopped, click the 'Stop' button.
2.
Select 'Replace photoconductor drum' on the operator panel menu under
'VarioStream', 'Changing consumables'.
3.
Click the 'OK' button to start the procedure.
Information on the icons displayed on the operator panel under
'Work-steps': see
4.
Open the cover and both doors at the front of the printing system.
[565]
5.
[566]
6.
400
Chapter 9 Replacing expendables
399.
Explanation of icons on page
Replacing the photoconductor
118.
Open door to photoconductor
drum.
Pull lever forward.
Push safety lever to the right
and pull up door by lever.
Advertisement
Table of Contents
