Preparing To Replace The Fuser Roller And Removing The Heating Element - Oce VarioStream 8000 User Manual

Continuous printing system

Hide thumbs Also See for VarioStream 8000:

Table of Contents

Preparing to replace the fuser roller and removing the heating element

Proceed as follows:

Open the right door at the back of the printing system.

Turn the knob of the oiling unit

to the left to open it and swivel

the oiling unit open.

Move the temperature sensor

lever to the left.

The temperature sensor strip is

now swiveled up.

Loosen the heating element

connector plug on the front side

of the printing system and

straighten the cable.