Table of Contents
Advertisement
Proceed as follows:
[596]
4.
[597]
5.
6.
Close side door of fuser station.
7.
Indicate on the operator panel whether a new cleaning belt was fitted:
'Yes'
The consumable counter is reset.
'No', if the pressure roller is not replaced, but instead just cleaned, for ex-
ample.
The consumable counter is not reset.
In both cases, the message on the operator panel is automatically deleted,
and the replacement of the pressure roller is recorded in the 'Consumables
history' menu.
8.
Click the 'OK' button on the operator panel to complete the procedure:
All units of the printing system are inspected (duration around 2-3 minutes),
before the printing system is switched to the 'Ready' status.
Install cleaning belt
Turn the new roller with the un-
used cleaning belt in the oppo-
site direction to the direction of
travel until the cleaning belt is
tight and contains no creases.
Swivel on oiling unit and turn
the oiling unit knob to the right
to lock it.
417
Advertisement
Table of Contents
