Table of Contents
Advertisement
Proceed as follows:
[429]
3.
4.
Close the left and center door at the back of the printing system.
5.
Click the 'OK' button on the operator panel to complete the procedure.
All aggregates of the printing system are inspected (duration around two to
three minutes) before the printing system is switched to the 'Ready' status.
[430]
Important
Only when using CustomTone
for mixing the developer begins automatically. This procedure takes ap-
proximately 5 minutes. The print job will then continue automatically.
Swivel on the fan to the devel-
oper station and turn the knob
to the right.
®
: After a print job is started, a procedure
Fill developer
317
Advertisement
Table of Contents
