Table of Contents
Advertisement
Proceed as follows:
[360]
Caution
The components in the fuser station reach a surface temperature of approx-
o
imately 230
Do not touch any parts behind the safety covers identified with this icon:
[361]
[362]
3.
4.
Swivel on cleaning station.
[363]
Caution
The components in the fuser station reach a surface temperature of approx-
o
imately 230
Allow the printing system to cool down for at least 30 minutes, with the fus-
er station open.
Put on the heat protection gloves.
5.
Allow the printing system to cool down for approximately 30 minutes.
6.
Put on heat protection gloves.
[364]
7.
8.
Soak a fluff-free towel (e.g. paper towel) with cleaning agent 6-1508/W1/H.
C. Touching the components can cause burns.
C. Touching the components can cause burns.
Clean soft fuser roller
Turn the knob on the cleaning
station to the left.
Press against the pressure pin
and swivel out the waste collec-
tor.
271
Advertisement
Table of Contents
