Table of Contents
Advertisement
Remove cleaning belt
Remove cleaning belt
Caution:
Observe the safety directives in the section
overview on page
To replace the cleaning belt
[222]
Proceed as follows:
1.
If the printing system has not yet stopped, click the 'Stop' button.
2.
Select 'VarioStream' -> 'Changing consumables' -> 'Replace cleaning belt'
on the operator panel menu.
3.
Click the 'OK' button to start the procedure.
Information on the icons displayed on the operator panel under
'Work-steps': see
4.
Open the side door of the fuser station.
[588]
5.
[589]
Caution
The components in the fuser station reach a surface temperature of approx-
imately 230
Do not touch any parts behind the safety covers identified with this icon:
[590]
6.
Wear protective gloves.
414
Chapter 9 Replacing expendables
413.
Explanation of icons on page
o
C. Touching the components can cause burns.
Replacing the cleaning belt -
118.
To open, turn the knob of the
oiling unit to the left and swivel
up the oiling unit.
Advertisement
Table of Contents
