Permitting or blocking remote access
Introduction
The Service can make a remote diagnosis during printing using remote access if this
has been agreed beforehand.
To enable remote access
[231]
Proceed as follows:
1.
Click on the following button in the toolbar:
[632]
or click on the 'Remote diagnostics disabled' button in the 'VarioStream' ->
'Configuration' -> 'Special functions' -> 'Remote diagnostics' menu.
The status display shows that remote access is enabled:
[633]
To disable remote access
[232]
Proceed as follows:
1.
Click on the following button in the toolbar:
[634]
or click on the 'Remote diagnostics permitted' button in the 'VarioStream' ->
'Configuration' -> 'Special functions' -> 'Remote diagnostics' menu.
Permitting or blocking remote access
435