Cleaning the toner dust sensor
Proceed as follows:
4.
Close the left and center door at the back of the printing system.
5.
Indicate on the operator panel whether a new fine filter was installed:
6.
Click the 'OK' button on the operator panel to complete the procedure:
All aggregates of the printing system are inspected (duration around two to
three minutes) before the printing system is switched to the 'Ready' status.
280
Chapter 7 Cleaning the printing system
'Yes'
The message on the operator panel is deleted automatically, the replace-
ment of the active filter is recorded in the 'Consumables history' menu
and the consumable counter is reset.
'No'
The consumable counter is not reset.