Table of Contents
Advertisement
Cleaning
agents/equip-
ment
Round brush
Foam cloth
Dusting brush Cleaning hard-to-reach
Vacuum
cleaner
Cleaning felt
with handle
Cleaning intervals
[134]
Time
After every change of shift
or every 8 hours
Weekly or after 500,000 sheets
Cleaning agents and devices, cleaning intervals
Purpose
Cleaning the toner dust
sensor
To clean surfaces
areas
To remove paper dust
and residue, toner and
developer residue/spill
Cleaning the paper
edge sensor
Note
Standard store-bought quality
e.g. pipe cleaner EGRA-bunt, OLD-
ENKOTT, etc.
MOLTOPREN or similar qualities
1 cm (1/2") round brush and flat paint
brushes (2"), commercial quality with
NYLON or hair bristles.
Do not use brushes with metal casings.
[320]
Caution
Always use an industrial vacu-
um cleaner with a grounded
suction tube, rubber nozzle and
filter set for fine dust. For large
toner volumes (e.g. 1 bottle), an
explosion-proof industrial vac-
uum cleaner must be used.
supplied; available only from Océ Print-
ing Systems
Cleaning loca-
tion
Paper path
Plastic strips
Fuser station
Developer station
Transfer roller
See section ...
Clean the paper path on
page 255
Clean plastic strips on
page 262
Clean fuser station on
page 264
Clean the developer
station. on page 273
Clean transfer roller on
page 261
253
Advertisement
Table of Contents
