Table of Contents
Advertisement
Paper guide for reverse-side printing
Proceed as follows:
[172]
5.
[173]
6.
7.
Tighten the knurled screws again.
[174]
8.
9.
Only when changing the paper width:
Loosen knurled screw.
152
Chapter 6 Operating the printing system
For < 250 mm paper widths:
Guide the paper from above
through the lower guide rods to
the lower deflection roller.
Only when changing the <
250mm paper width:
Loosen the four knurled
screws of the left and right
lower alignment rings on
both guide rods.
Push the paper path delimit-
er until the paper lies in the
middle of the lower deflec-
tion roller.
There must be some space
between the paper and the
alignment ring.
Guide the paper between the
two slanted guide rods to the
rear slanted guide rod to the
vertical deflection roller.
Advertisement
Table of Contents
