Table of Contents
Advertisement
Clean fuser station
Clean fuser station
Caution:
There can be a high build-up of static charge when vacuuming the toner
spill.
Always use an industrial vacuum cleaner with a grounded suction tube,
rubber nozzle and filter set for fine dust. For larger toner quantities, the
industrial vacuum cleaner must be explosion-proof.
To clean the fuser station
[139]
Proceed as follows:
1.
If the printing system has not yet stopped, click the 'Stop' button.
2.
Open the front and side door of the fuser station.
[343]
Caution
The components in the fuser station reach a surface temperature of approx-
imately 230
Do not touch any parts behind the safety covers identified with this icon:
[344]
[345]
3.
4.
Swivel on oiling unit.
[346]
Caution
The components in the fuser station reach a surface temperature of approx-
imately 230
Allow the printing system to cool down for at least 30 minutes, with the fus-
er station open.
Put on the heat protection gloves.
5.
Allow the printing system to cool down in this state for at least 30 minutes.
264
Chapter 7 Cleaning the printing system
o
C. Touching the components can cause burns.
o
C. Touching the components can cause burns.
Turn the knob on the oiling unit
to the left.
Advertisement
Table of Contents
