Table of Contents
Advertisement
Inserting the fuser oil bottle
Inserting the fuser oil bottle
Caution:
When replacing the fuser oil bottle, observe the safety directives in section
Replacing the fuser oil bottle - overview on page
To install the new fuser oil bottle
[169]
Proceed as follows:
[434]
1.
2.
Wipe away any spilled oil with a paper towel.
[435]
Important
The hose can bend. The fuser oil cannot be filled in this case.
Ensure that the hose is not bent when you tip the vacuum container back.
[436]
3.
4.
Check the waste oil container fill level.
If the waste oil container is full: see
overview on page 324
5.
Close the center door at the back of the printing system.
322
Chapter 8 Replacing consumables
319.
Insert the new fuser oil bottle so
that the handle faces out.
Swivel the fuser oil bottle hold-
er with the full fuser oil bottle
back into place. Make sure that
there is no bend in the hose.
Replacing the waste oil container —
Advertisement
Table of Contents
