Clean The Guide Plate And Replace The Foams And Roller Assy - Oce Colorado 1640 Operation Manual

Clean the guide plate and replace the foams and roller assy

Clean the guide plate and replace the foams and roller assy
Introduction
When you see your print is polluted with a clear ink stamp coming from the guide plate, you must
clean the guide place and replace the foams and roller assy.
Before you begin
Use Océ Colorado 1640 prescribed:
• Nitrile gloves for handling ink
• Lint free cloths and swabs
• Cleaning liquid (IPA)
NOTE
For information on the prescribed maintenance materials, see
maintenance materials on page
CAUTION
Wear the Océ Colorado 1640 prescribed nitrile gloves. You can only wear the gloves for ten
minutes. After ten minutes you must put on new gloves to prevent contact with the ink.
Procedure
1. Make sure the printer is not printing and the guide plate is in open position.
2. Remove the media before you replace the foams and roller assy. For more information, see
Remove media from the paper path on page 212
3. Put on the Océ Colorado 1640 approved nitrile gloves.
244 Chapter 8 - Troubleshooting and support
160.
List of Océ Colorado 1640