Table of Contents
Advertisement
Replacing the corotrons - overview
Replacing the corotrons
Replacing the corotrons - overview
Introduction
The printer detects the end of the corotron's service life automatically and displays
a warning on the operator panel.
Attention: When replacing the corotrons, observe the following safety
directives:
Corotrons can only be replaced when printing is stopped.
Corotrons may only be used for the purpose for which they were originally
intended.
If the corotron had only a short service life, the cause of the problem must be
identified in order to prevent further damage.
When replacing a corotron, always wear the gloves provided.
Ensure that you do not touch or damage the corotron wires.
Replace corotrons
The following procedure is for replacing all corotrons:
Preparing corotron replacement on page 361
Remove charge corotrons on page 362
Install charge corotrons on page 363
Remove discharge corotrons on page 366
Install discharge corotrons on page 367
Complete corotron replacement on page 370
Replace torn charge corotron
The following procedure is for replacing a torn charge corotron:
Remove torn charge corotron on page 364
Install charge corotrons on page 363
Replace torn discharge corotron
The following procedure is for replacing a torn discharge corotron:
Remove torn discharge corotron on page 368
Install discharge corotrons on page 367
360
Chapter 9 Replacing expendables
Advertisement
Table of Contents
