Table of Contents
Advertisement
Remove cleaning brush
Remove cleaning brush
Caution:
Observe the safety directives in the section
overview on page
To remove the cleaning brush
[220]
Proceed as follows:
1.
If the printing system has not yet stopped, click the 'Stop' button.
2.
Select 'VarioStream' -> 'Changing consumables' -> 'Replace cleaning brush'
on the operator panel menu.
3.
Click the 'OK' button to start the procedure.
Information on the icons displayed on the operator panel under
'Work-steps': see
4.
Open the cover and both doors at the front of the printing system.
[578]
Important
Wear the protective gloves provided in the packaging.
Do not touch the outside of the cleaning brush; hold only by the inside.
Only place the cleaning brush in an upright position, with the brush hairs
facing upwards.
5.
Wear protective gloves.
[579]
6.
408
Chapter 9 Replacing expendables
407.
Explanation of icons on page
Replacing the cleaning brush —
118.
Open door to the photoconduc-
tor drum.
Pull the lever forward.
Advertisement
Table of Contents
