Rocker Arm And Shaft Assembly (4.0L) - Mazda B-Series 1997 Workshop Manual

ON-VEHICLE MAINTENANCE
6. Tighten the new cylinder head bolts in the order shown in
the figure.
Tightening torque:
70-75 N-m (7.0-7.5 kgf-m, 52-56 ft-lbf)
7.Tighten the lower intake manifold bolts and nuts in the
order shown in the figure.
Tightening torque:
8-15 N.m (0.82-1.5 kgf.m, 6-1 1 ft-lbf)
8. Tighten the new cylinder head bolts an additional 90" in
the order shown in the figure.
9. Tighten the lower intake manifold bolts and nuts.
Tightening torque:
15-22 N . m (1.5-2.2 kgfsm, 11-16 ftalbf)
6BUOB3-001
Rocker arm and shaft assembly
I . Install the push rods.
2. Install the rocker arm and shaft assemblies.
3. Tighten the rocker arm shaft bolts.
Tightening torque:
32 N.m (3.3 kgf.m, 24 ft.lbf)
+
90 degrees
Caution
The bolts should be tightened gradually, two turns
at a time.