Oil Pressure - Inspection (4.0L); Preparation - Mazda B-Series 1997 Workshop Manual

OIL PRESSURE
OIL PRESSURE
PREPARATION
SST
1
49 0187 280
1
For
I
2. Screw the SST into the oil pressure sensor installation
hole.
3. Warm up the engine to normal operating temperature.
4.Run the engine at 2000 rpm, and note the gauge
readings.
Oil pressure: 2 7 6 4 1 3 kPa (2.8-4.2 kgf/cm2,
40-60
psi)
-2,000
rpm
5. If the pressure is not as specified, check for the cause and
repair as necessary. (Refer to Troubleshooting Guide.)
6.Apply sealant to the oil pressure sensor threads as
shown in the figure.
7. Remove the SST and install the oil pressure sensor.
Tightening
torque:
11-16
N-m
(1.1-1.7 kgf-m, 8-12 ft.lbf)