Table of Contents
Advertisement
ON-VEHICLE MAINTENANCE
ONT
OF
ENGINE
Dipstick tube
Install the dipstick tube.
Tightening torque:
16-20 N.m (1.6-2.0
kgf.m, 12--15 ftelbf)
5BUOB2-016
Spark plugs
lnstall the spark plugs.
Note
If installing the original spark plugs, install them in
their original location.
LH BANK: WHITE
RH BANK: DARK GREEN
Tightening torque:
9-20
N.m (0.9--2.0 kgf.m, 7-14 ftelbf)
5BUOB2-017
Cylinder head covers
1. Apply a bead of sealer at the cylinder head-to-intake
manifold rail step (two places per rail).
2. Position the cover on the cylinder head.
Note
When positioning the cover to the cylinder head,
use a straight down approach to align the holes.
Once the cover comes in contact with the RTV
sealer, any adjustment for bolt alignment can roll
the gasket from the cover channel, resulting in
leaks.
Tightening torque:
10-1
4
N-m (1 .&I .4 kgfem, 7-1 0 ft.lbf)
3. If installing the left cylinder head cover, perform the
following:
(1) lnstall the fuel injector harness .stand-offs to the in-
board cylinder head cover studs.
(2) lnstall the PCV valve and connect the hoses.
(3) lnstall the upper intake manifold/i:hrottle body assem-
bly.
(4)
lnstall the fuel line bracket to the front of the cylinder
head.
Tightening torque:
35 N-m (3.6 kgf.m, 26 ft-lbf)
(5) lnstall the power steering oil pump and bracket assem-
bly, if equipped.
Tightening torque:
40-42 N-rn {4.0--6.2 kgfern, 30--46 ft.lbf)
(6)
lnstall the drive belt.
Advertisement
Table of Contents
Troubleshooting
