Engine Oil (4.0L); To Replace Engine Oil (4.0L); Inspection; Replacement - Mazda B-Series 1997 Workshop Manual

ENGINE OIL
KEEP THE OIL IN THlS RANGE
INSPECTION
I
1. Position the vehicle on level ground.
I 1
5. Add or replace oil as necessary.
m
'+
OIL LEVEL MAY BE IN THlS
RANGE AFTER AN OIL CHANGE
MB1250-C
I
5HUOD3-004
Note
The oil level should be filled to the top of the dashed
2. Warm up the engine to normaloperating temperature and
stop it.
3.
Wait for five minutes.
4. Remove the oil dipstick and check the oil level and
condition.
part of the oil dipstick.
REPLACEMENT
Warning
Be careful when draining; the oil is hot.
--
1.
Warm up the engine to normal operating temperature and
stop it.
2. Remove the oil filter cap and the oil pan drain plug.
3. Drain the oil into a suitable container.
4. Install a new gasket and the oil pan drain plug.
FRONT OF ENGINE
Tightening torque:
MD1048-A 4EIUOD3-006
21-28 N.m (2.1-2.8 kgf-m, 15--21 ft-lbf}
5. Refill the engine with the specified type and amount of
engine oil.
Oil capacity
liters {US qt, Imp qt}
I
Engine oil replacement
I
3.8 14.0, 3.4)
I
I
Engine oil replacement (with oil filter)
I
4.7 (5.0, 4 . 2 1
I
6. Refit the oil filler cap.
7. Run the engine and check for leaks.
8. Check the oil level and add oil if necessary.