Mazda B-Series 1997 Workshop Manual page 802

ON-BOARD DIAGNOSIS SYSTEM
I
STEP
/
INSPECTION
7
ACTION
7
7 Drain fluid and remove fluid pan.
Check internal harness connector is fully seated on TFT sensor.
Check internal harness connector terminals are fully engaged in
connector.
Inspect connectors for damage.
I s evewthina
OK?
6
Using trans tester, check continuity between
BAT-
(engine
1
Yes Go to step
7.
ground) and appropriate jack (-TFT or +TFT). Connection should
No
1
Service as required. Replace internal harness.
show infinite resistance (no continuity)
1
No T ~ e p l a c e P C M GO to step 8.
/
Is there continuity?
Yes
1
8
1
Perform After Repair Procedure to ensure customer's concern has been resolved.
I
Repeat self-tests. If codes are present and over-
temp condition exists, check fluid.
Refer to Quick Diagnosis Chart in this section for
overheat conditions. Service as required.