Inspection Of Brake And Clutch Fluid; Inspection Of Power Steering Fluid Level; Inspection Of Tires - Mazda B-Series 1997 Workshop Manual

A
SCHEDULED MAINTENANCE SERVICES
TO CHARCOAL CANISTER
/
VALVE
wv
3
3.0L
1.
Remove the PCV valve from the cylinder head cover.
2. Shake the PCV valve.
3. Verify that the PCV valve rattles when shaken.
4.
If the PCV valve does not rattle (sticking), then replace it.
5. Reinstall the PCV valve and hoses.
6. Warm the engine at idle.
7. Disconnect the hose from the PCV valve leading to the
throttle body.
8. Block the hose opening.
9. Verify that vacuum is felt.
10. If no vacuum is felt, check for restrictions and replace the
hose if it is restricted or leaking.
11. Inspect the evaporative emission hose between the PCV
valve and the charcoal canister, and replace it if it is
leaking.
INSPECTION OF BRAKE AND CLUTCH FLUID
Check the fluid level in the reservoir. The level should be
at the MAX line on the reservoir.
If the fluid level is extremely low, check the brake system
for leaks.
Fluid specification: FMVSSI 16 or DOT-3
INSPECTION OF POWER STEERING FLUID LEVEL
Check the fluid level. When cold, the level should be at the
FULL COLD mark. When hot, the level should be at the
FULL HOT mark. Add fluid if necessary.
Fluid specification: ATF DexronBII or M-111
4BUOAX-044
INSPECTION OF TIRES
Inspection and Adjustments
A wheel or tire should be replaced if any cracks, damage,
deformation or other problem(s) are found.