Retrieve/Clear Continuous Dtcs; Koeo On-Demand Self-Test - Mazda B-Series 1997 Workshop Manual

C)N-BOARD DIAGNOSIS
SYSTEM
FT
ABS
-
ANTILOCK BRAKE SYSTEM
GEM
-
GENERIC ELECTRONIC MODULE
IABM
-
INTEGRATED AIR BAG MODULE
RAP - REMOTE ANTI-THEFT MODULE
I
I
4
SELECT ITEM AND PRESS TRIGGER TO START
I
8. Move the cursor to PCM. Press trigger.
9. Move the cursor to DIAGNOSTIC TEST MODE. Press
the trigger key to enter this selection.
ACTIVE COMMAND MODES
DIAGNOSTIC TROUBLE CODE LIBRARY
I I
MF2022-A
1 10. Move the cursor to appropriate mode. Press the trigger
key to enter this selection.
11
. Retrieve DTCs as follows:
RETRIEVWCLEAR CONTINUOUS DTCS
1
1 ) Continuous DTCS
I I 1
KOEO ON-DEMAND SELF TEST
KOER ON-DEMAND SELF TEST
ON BOARD SYSTEM READINESS TESTS
2)
KOEO DTCs
3)
KOER DTCs
I' SELECT ITEM AND PRESS TRIGGER TO START
I'
I
Note
The first test to run is RetrieveIClear Continuous DTCs. Record the DTCs on a piece of paper
and proceed to the KOEO test.
Note
The purpose of recording continuous DTCs at this time is to make sure they are not uninten-
tionally cleared during any KOEO or KOER service. KOEO and KOER codes are always
addressed before continuous codes.
5BUOF-112
RetrievelClear Continuous DTCs
1. Move the cursor to RETRIEVEICLEAR CONTINUOUS DTCs.
Press the trigger key to enter this selection.
2. Turn key on. Press START.
3. Follow operating instruction frorn the menu.
4. If there are DTC(s), refer to Diagnostic Trouble Code Chart on page FT-77 for further diagnosis informa-
tion. After repairs, clear DTCs. Press "C-ALL" (Key
#7)
button and press trigger.
5.
If there are no codes, press CANCEL. Perform KOEO On-Demand Self-Test.
KOEO On-Demand Self-Test
~BUOFT-046
1.
Move the cursor to KOEO ON-DEMAND SELF-TEST.
Press the trigger key to enter this selection.
2.
Turn key on. Press START.
3. Follow operating instruction frorn the menu.
4.
Note any KOEO DTCs. Press CANCEL. Perform KOER On-Demand Self-Test.