Magnetic Switch Inspection - Mazda B-Series 1997 Workshop Manual

G
STARTING SYSTEM
6. lnstall the brush holder.
7. Insert the brushes in holder.
8. lnstall the brush springs.
9. lnstall the rear cover.
10. lnstall the two through-bolts.
Tightening torque:
5-10 N.m (51-102 kgfecm, 4 4 - 4 8 in-lbf)
11. Install the starter drive plunger lever cover and tighten
the screw.
Inspection
Magnetic switch
1. Remove the magnetic switch from the starter.
2. Check for continuity between Terminals S and M.
3. Check for continuity between Terminal S and the body.
4.
Check for no continuity between Terminals B and M
5. Replace the magnetic switch if not as specified.