Table of Contents
Advertisement
ON-VEHICLE MAINTENANCE
Steps After Installation
1. Connect the negative battery cable.
2. Start the engine and check as follows:
(1) Engine oil leakage
(2) Drive belt for proper routing
3. Check the engine oil level.
Installation note
Front oil seal
Note
Inspect the timing cover and the shaft seal surface
of the damper for damage, nicks, burrs, or other
roughness which may cause the new seal to fail.
Service or replace components as necessary.
Lubricate the seal lip with clean engine oil and install the
seal using Damper and Front Cover Seal Installer T82L-
631 6-A and Front Cover Seal Replacer T70P-6B070-A, or
equivalents.
4BUOB2-056
Damper
1. Coat the damper sealing surface with clean engine oil.
2. Apply sealer to the keyway on the damper prior to instal-
lation.
3. Install the damper using Damper arid Front Cover Seal
Installer T82L-6316-A, or equivalent.
4. Install the washer and bolt.
Tightening torque:
125-1 65 N.m
(1
2.7-1 6.8 kgf-rn, 92-1 22 ft.lbf)
5BUOB2-026
Crankshaft pulley
Install the crankshaft pulley.
Tightening torque:
32 N.m (3.3 kgf-m
,
24 ft-lbf)
REAR OIL SEAL
Replacement
1.
Remove the transmission. (MT, Refer to Section J1 ; AT, Refer to Section K.)
2. Remove the clutch cover and disc (MT). (Refer to Section H.)
3. Remove the flywheel (MT), referring to Removal Note. (Refer to page B2-20.)
4. Remove the drive plate (AT), referring to Removal Note. (Refer to page B2-20.)
5. Remove the rear oil seal, referring to Removal Note. (Refer to page B2-20.)
6. Install in the reverse order of removal, referring to Installation Note.
Advertisement
Table of Contents
Troubleshooting
