Clutch Pedal Position (Cpp) Switch (Mt Only); Transmission Range Sensor (A/T Only) - Mazda B-Series 1997 Workshop Manual

CONTROL SYSTEM (FOR 2 . 3 ~ 1 3 . 0 ~ 1 4 . 0 ~ )
FT
CLUTCH PEDAL POSITION (CPP) SWITCH (MT ONLY)
If the clutch pedal position switch circuit has an open or
short, Diagnostic Trouble Code No. PO704 is output.
If the clutch pedal position switch is open or shorted,
vehicle will not start or speed control will not disengage
properly or idle speed will be too high with clutch pedal
depressed.
lnspection
1. Disconnect the clutch pedal position switch connector.
2. Connect an ohmmeter to the switch, as shown.
3.
Check the continuity of the switch between the terminals,
as shown.
Specification:
I
Pedal
1
(2ontinuity
I
I
Depressed
I
Yes
1
4. If not as specified, replace the clutch pedal position
switch. (Refer to Section H.)
Released
TRANSMISSION RANGE SENSOR (A/T ONLY)
No
lnspection
Refer to Section K.
MF1666-A
Replacement l Adjustment
Refer to Section K.
OVERDRIVE DRUM SPEED (ODs) SENSOR (AIT ONLY)
lnspection
Refer to Section K.
OUTPUT SHAFT SPEED (OSS) SENSOR ( A n ONLY)
lnspection
Refer to Section
K.
FT-I 89