In-Shop Test; Vehicle Speed At Shift Point Tables - 2.3L - Mazda B-Series 1997 Workshop Manual

ROAD TEST
K
IN-SHOP TEST
This test is performed to check shift valve operation, shift delay pressures, and downshift valve operation.
1. Raise the vehicle to lift the rear wheels off the ground.
2. Start the engine.
Caution
Never exceed 96 kmlh
(60
mph) while performing this test.
3. Shift
the selector lever into
0
range.
4. Accelerate the vehicle with minimum throttle.
5. Verify the 1 -+2,2+3,3+0/D shifts and that the shift points are as shown in the vehicle speed at shift point
table. (Refer to page K-9.)
6. If the shift points are within specification, the 1-2,2-3,3-4 and torque converter clutch shift valves are OK.
7. Shift the selector lever into N range and run the engine at 1000 rpm for 15
sec.
to cool the transmission.
6BUOKX-386
Vehicle Speed at Shift Point Tables
2.3L
Throttle position
Minimum throttle
Closed throttle
- -
Part throttle
Range
0
0
I
Manual pull-down
1
1
1
2-1
1
49-56 {30-35)
1
Shift
Wide open throttle
Axle ratio: 3.73
kmlh {mph)
3-2
2-1
2 1 -32 { I 3-20)
10-1 7 (6-1 1 )
@
0
0
0
1-2
2-3
3-2
3-1,2-1
60-69 {37-43)
107-1 19 (66-741
98-1 1 1 {61-69)
50-62 {31-39)
I