Replacement Of Manual Transmission Oil; Inspection Of Automatic Transmission Fluid Level - Mazda B-Series 1997 Workshop Manual

SCHEDULED MAINTENANCE SERVICES
A
2. Verify that the oil is near the bottom of the plug port.
3. If the oil level is low, add the specified amount and type of
oil through the oil level plug hole.
Fluid specification: ATF DexronB1l or M-111
-
4. Install a new washer and the oil level plug.
Tightening torque:
40-58 N.m (4.1-5.7 kgf.m, 30--42 ft-lbf)
REPLACEMENT OF MANUAL TRANSMISSION OIL
1. Remove the drain plug with washer.
2. Drain the oil into a suitable container.
3. Install a new washer and the drain plug.
Tightening torque:
40-58 N-m (4.1-5.7 kgf-m, 30--42 ft-lbf}
OIL LEVEL
I
DRAIN PLUG
MJ1157-A
4.
Remove the oil level plug with washer and add the
specified amount and type of oil through the oil level plug
hole until the level reaches the bottom of the oil level plug
hole.
Fluid specification: ATF MerconB or M-I11
Capacity: 2.65 liters (5.6 US pt, 4.5 Imp pt)
5. Install a new washer and the oil level plug.
L
MJI 137-A ~BUOAX-054
Tightening torque:
40-58 N.m (4.1-5.7 kgf-m, 30-42 ft.lbf)
INSPECTION OF AUTOMATIC TRANSMISSION FLUID
Level
Note
Place the vehicle on a flat, level surface.
1. Apply the parking brake and position the wheel chocks
securely to prevent the vehicle from rolling.
2.
Warm up the engine until the ATF: reaches 6 6 7 7 ° C
(1 50-1 70°F).
3. While depressing the brake pedal, shift the selector lever
to each range (Park through 1 st), pausing momentarily in
each range.
4. Shift back to Park.
Note
Vehicles equipped with 4x4 applications must
have the 4x4 shift lever in any position other than
Neutral.