ON-VEHICLE MAINTENANCE
FRONT OF ENGINE
FRONT OF
ENGINE
INSTALLED
HEIGHT
SECTION A
0.5 mm
(0.02 in}
Removal note
Flywheel (MT)
Remove the bolts and the flywheel.
Drive plate (AT)
Remove the bolts, the reinforcement plate and the drive
plate.
Rear oil seal
Note
Clean exterior surface of seal and cylinder block
prior to removal of seal.
Using a sharp awl, punch one hole into the rear oil seal
metal surface between the lip and block. Screw in the
threaded end of Jet Plug Remover T77L-9533-B, or
equivalent and remove the seal. Avoid scratching or
damaging the oil seal surface.
5BUOE2-027
Installation note
Rear oil seal
1. Apply clean engine oil to the outer lips and the inner seal
edge.
2. Position the seal onto the SST.
3. Install the seal and alternate bolt tightening to seat the seal
properly.
Protrusion: 0.5mm
(0.02
in)