Vacuum Hoses Installation (4.0L); A/C Compressor Installation (4.0L); Power Steering Oil Pump Installation (4.0L); Air Intake Hose Installation (4.0L) - Mazda B-Series 1997 Workshop Manual

INSTALLATION
Vacuum hoses
Connect the vacuum hoses to vacuum tee "A".
I
I
MBlO61-A 4BUOB3-169
AIC compressor
1. Position the A/C compressor on the bracket.
2. Tighten the AIC compressor bolts.
Tightening torque:
-
3 4 - 4 7 ~ . m ('3.54.6 kgf-m, 25-34 ftdbf)
4BUOB3-170
Power steering oil pump
1. Position the power steering oil pump on the bracket.
2. Tighten the power steering oil pump bolts.
Tightening torque:
-
40-55 ~ . m (4.1-5.5 kgf-m, 3 0 4 0 ftalbf)
4BUOB3-171
Air intake hose
1. lnstall the air intake hose.
2. lnstall the breather hose.
3. Tighten the clamps.
Steps After Installation
1. Fill the engine with the specified amount and type of engine oil. (Refer to Section 03.)
2.
Fill the radiator with the specified amount and type of engine coolant. (Refer to Section E3.)
3. If the transmission was drained, fill it with the specified amount and type of transmission oil. (MT: Refer
to Section J1, AT: Refer to Section K.)
4. Install the front wheels.
5.
Connect the negative battery cable.
6 . Start
the engine and check the following:
(1) Engine oil, transmission oil, and engine coolant leakage.
(2)
Drive belt tension (Refer to page
83-7.)
(3) Ignition timing, idle speed (Refer to page B3-8.)
(4) Operation of emission control system
7. Perform a road test
8. Recheck the engine oil and coolant levels.