Ignition Coil Removal (3.0L); Auxiliary Parts Removal (3.0L) - Mazda B-Series 1997 Workshop Manual

ON-VEHICLE MAINTENANCE
Removal note
Ignition coil
1. Disconnect electrical connector.
2. Remove the ignition coil nuts.
3.
Remove the ignition coil.
I
MB1348-A 513UOB2-008
I
FRONT OF ENGINE
7
Auxiliary parts (left side)
1. Remove the power steering oil pump bracket bolts and
nut, if equipped.
2. Remove the power steering oil pump, bracket and lines as
an assembly. Set them aside to prevent fluid leakage, if
equipped.
3. Remove the engine oil dipstick tube nut from the exhaust
manifold stud.
4. Remove the tube from the manifold.
5. Remove the fuel line bracket bolt from the front of cylinder
head.
L I
MB1280-B 5 ~ ~ 0 ~ 2 - 0 0 9
6. Remove the PCV valve.
7.
Remove the fuel injector harness stand-offs from the
inboard cylinder head cover studs and move them out of
the way.
Auxiliary parts (right side)
1. Disconnect the generator harness c:onnectors.
2.
Remove the belt tensioner bolts and the tensioner
assembly.
3. Remove the generator bracket and the adjusting arm
bolts.
4. Remove the bracket assembly.
5. Remove the closure hose from the (cylinder head cover.
6.
Disconnect the engine harness conn~?ctors from the cover.
7. Remove the fuel injector harness stand-offs from the
inboard studs. Move them out of the way.
8.
Remove the PCV closure from the hose oil fill adapter.
4BUOB2-032