Clutch Master Cylinder Removal/Installation; Removal / Installation - Mazda B-Series 1997 Workshop Manual

H
CLUTCH MASTER CYLINDER
CLUTCH MASTER CYLINDER
REMOVAL I INSTALLATION
Caution
Be careful not to spill clutch fluid on a painted surface. If spilled, wipe it off immediately.
1. Remove in the order shown in the figure, referring to Removal Note.
2. Inspect all parts and repair or replace as necessary.
3. Install in the reverse order of removal, referring to Installation Note.
4. After installation, bleed the clutch system. (Refer to page H-4).
2.1-2.7
(21.4-27.5 kgf-cm,
19-23
in. lbf}
11.4-15.5 {1.161.59,
8.4-11.5)
N - m {kgf.m,ft.Ibf)
MH1004-C 5BUOHX-006
1.
Master cylinder push rod
5. Bolts
2. Clutch pedal position switch
6. Clutch master cylinder
Removal / Installation ............. page H-7
Inspect for fluid leakage from cylinder bore
.....................
Inspection ............................... Section FT Installation Note page H-9
............................ Air bleeding page H-4
3.
Screw
4. Clutch pipe
Removal Note
........................
page H-8
FRONT OF
VEHICLE
MALE COUPLING
Removal Note
Clutch pipe
Caution
After removing the clutch pipe, plug it to avoid fluid
leakage.
1. Disconnect the clutch pipe from the transmission using
Clutch Disconnect Tool T88T-70522-A, or equivalent.
2. Slide the white plastic sleeve toward the clutch release
cylinder while applying a slight tug on the pipe.