Oil Pump Oil Seal Replacement - Mazda B-Series 1997 Workshop Manual

B1
ON-VEHICLE MAINTENANCE
CAM AND AUXILIARY
SHAFT SPROCKET TOOL
T74P-6256-6
Camshaft pulley
Remove the camshaft pulley using Cam and Auxiliary
Shaft Sprocket Tool T74P-6256-B, or equivalent.
Camshaft oil seal
Remove the camshaft oil seal using the SSTs.
Note
SST numbers: 49 UNO1 087 Seal Remover,
49 UN11 101 and 49 0223 6306 Impact Slide
Hammer.
5BUOB1-027
lnstallation Note
Camshaft oil seal
Install the camshaft oil seal using the Cam and Auxiliary
Shaft Seal Replacer T74P-6150-A, or equivalent.
4BUOB1-046
Timing belt outer cover
Install the timing belt outer cover.
Tightening torque:
8 - 2 N.m (0.8-1 .I kgf-m, 6 - 4 ft.lbf}
4811081 -047
OIL PUMP OIL SEAL
Replacement
1. Remove the drive belt. (Refer to Section G.)
2. Recover the refrigerant from the A/C system. (Refer to Section G in the 1997 B-Series BETM.)
3. Remove the four AIC compressor bolts and position the AIC compressor aside.
4. Remove the A/C compressor and power steering pump mounting bracket bolts and position aside with
the hoses attached.
5. Remove the water pump pulley.
6. Remove the crankshaft pulley.
7. Remove the timing belt outer cover, referring to Removal Note. (Refer to page B1-21.)
8. Remove the timing belt. (Refer to page B1-8.)
9. Remove the oil pump pulley, referring to Removal Note. (Refer to page 8 1 -21 .)
10. Remove the oil pump oil seal, referring to Removal Note. (Refer to page B1-21.)
11. Install in the reverse order of removal, referring to Installation Note.
12. Check the ignition timing. (Refer to Section G.)