Tester Use (4R44E Only); Tester Hook-Up Procedure - Mazda B-Series 1997 Workshop Manual

ELECTRICAL SYSTEM COMPONENTS
K
TRANSMISSION TESTER
9 0 8
I
0 0 0
4RC(E/4RSSE
1
WCT.oLuopI
M-
Tester Use (4R44E Only)
The tester allows a technician to operate the electrical
portion of the transmission independently of the vehicle
electronics to allow the technician to determine transmis-
sion concerns. Tester use is divided into five parts:
Preparation
Hook-up Procedure
Inspection (In-shop)
Inspection (On-road)
Tester Removal
Preparation
1. Check transmission fluid.
2. Check for add-on items (phones, computers, CB radio,
etc.).
3. Inspect wiring harness and connectors.
4.
Check for vehicle modifications.
5. Check shift linkage adjustment.
6. Verify customer concern.
7.
Warm vehicle to normal operating temperature.
8. Perform On-board Diagnostics.
9. Record all DTCs.
10. Service all non-transmission codes.
7BUOKX-041
Hook-up Procedure
Note
During tester use additional DTCs may be set.
Therefore, it is important that all codes are erased
after service has been performed. To eliminate all
codes perform the After Repair Procedure. (Refer
to
K-34.)
1. Disconnect vehicle wiring harness at transmission
connector.
Caution
Do not pry off connectors with a screwdriver. This
could damage the connector resulting in transmis-
sion concerns.
If vehicle is equipped with heat shields, remove
them. Always replace heat shields after service.
Route all cables away from heat sources.
2. Set tester solenoid switch to OHMS CHECK position.
3. Install appropriate overlay onto tester.
SST No.
49 UNOl 132
4.Connect appropriate interface cable to tester and
transmission.
SST No.
49 UNO1 132