Oil Pump With Intermediate Shaft (3.0L); Drive Plate Installation (3.0L); Flywheel Installation (3.0L) - Mazda B-Series 1997 Workshop Manual

ASSEMBLY
FRONT OF ENGINE
FRONT OF
-
ME1 167 A
' 5 81
CLUTCH ALIGNER
Assembly Note
Oil pump with intermediate shaft
1. Install the oil pump and intermediate shaft.
2.
Tighten the bolts to specification.
Tightening torque:
40-55 N-m (4.1-5.5 kgf-m, 3 0 4 0 ftalbf)
Drive plate (AT)
Install the drive plate and reinforcement plate and install
the bolts usirig the standard cross-tightening sequence.
Tightening torque:
7 3 - 4 7 N.m (7.3-4.7 kgf-m, 541-64 ftelbf)
Flywheel (MT)
Install the flywheel on the crankshaft using Clutch Aligner
T71 P-7137-H, or equivalent. Install the bolts using the
standard cross-tightening sequence.
Note
The three dowels must be bottomed out in the
flywheel.
Tightening torque:
7 3 - 8 7 N.m (7.3-4.7 kgf-m, 54-64 ft-lbf)