Mazda B-Series 1997 Workshop Manual page 732

ELECTRONIC SHIFT TRANSFER CASE
I
Problem Action
'
~ a a e ?
1
Excessive tire tread wear
Transfer case makes noise
Internal components
lncorrect tire inflation
pressures or incorrect size
tires and wheels
4-Wheel drive transfer case Incomplete shift linkage
Make sure that all tires and wheels are the Section
same size, and that inflation pressures are correct.
1
Check tire tread wear to see if there is more than
.06 inch difference in tread wear between front Sectlon
and rear. lnterchanae one front and one rear Q
"
wheel. Reinflate tires to specifications
OPERATE vehicle in all transmisslon aears
gears wlth transfer case In 2H, or ~1~h;an~e
- -
If there
IS
nolse In transmlsslon In neutral gear, or Section
In some gears and not In others, remove and J1 or
K
repalr transmlsslon.
If there 1 s nolse In all gears, operate vehlcle In
all transfer case ranges. If nolsy In all ranges or
Hlgh range only,
disassembly transfer case.
Check Input gear, lntermedlate and front output J2-39
shaft gear for damage. Replace as requlred
If nolsy In Low range only, Inspect lntermedlate
gear and slldlng gears for damage.
Replace as required.
- - - -
-
--
Adjust llnkage to provlde complete gear
-
jumps out of gear
!
travel
1
engagement. Adjust shift lever rubber boot
L
Loose mounting bolts Tighten mountlng bolts -
. -
-
pp
---
Lubricate and repalr slip yokes as requ~red.
dry or loose Tighten flange yoke attaching nut to -
. - - -
Internal components Disassemble
transfer case. Inspect slldlng clutch
hub and gear clutch teeth for damage. Replace J2-39
'
as requlred
Locking hubs will not
release
I
Drivelinelvehicle torsional
/
lockur,
Stop vehicle. Drive vehicle in reverse for 10 feet
-
I
1
Extremely cold ambient
/
temperatures
Drive vehicle 10 miles to warm axle, then try to
disenaaae hub locks
Driveline/torsional windup
vehicle hop, wheelitire
bounce, vehicle skip
Incorrect tire inflation
pressures or incorrect size
tires and wheels
-
.
- -
-
- -
-
-
Excessive tire tread wear
Drlvlng vehlcle on hard
surfaceidry surface roads or
areas Drlvlng vehlcle In tlght
- - -
- -
turns
- - - - -
- -
- -
Delayed sh~fts to 2WD
1
Dr~velineitors~onal wlndup
- - - - - -
Extremely cold ambient
ternDeratures
Make sure that all tires and wheels are the same Section
size, and that inflation pressures are correct Q
- -
-
- -
- - -
- -
-
- - - - -
Refer to vehicle owner's guide for correct usage
of vehlcle. Advise owner
- -
- - - - - -
-
Shlft transmisslon Into neutral Jack the vehlcle
or lift on holst wlth wheel free to rotate Wlndup
will be released and transfer case wlll complete ~ t s
sh~ft
- - - - - - - - -
-
-
Drlve vehicle 10 m~les to warm axle, then try to
dlsenaaae hub locks