ELECTRONIC SHIFT TRANSFER CASE
Motor assembly
1. Rotate the shift shaft to align it with the slot in the motor.
Note
If shift shaft will not stay in position, rotate the
motor counterclockwise during installation.
2. Apply sealant to the motor housing base.
3. Loosen the motor bracket nuts.
4. Install the wire harness bracket and motor assembly.
Tightening torque:
8.1-10.8
N.m (0.82-1.1
kgfsm, 6-43 ft.lbf)
5. Install the motor bracket.
Tightening torque:
Bolt: 8-1 1 N-m (0.82-1.1
kgf.m, 5.9-4.1 ftelbf)
Nuts: 2 4 N.m (0.2-0.4
kgf.m, 1.5-3.0
ftelbf)
6. Install the brown wire into the motor connector.
58UOJ2 032