Lower Intake Manifold; Exhaust Manifold; Water Inlet Tube; Dpf Egr Sensor - Mazda B-Series 1997 Workshop Manual

ON-VEHICLE MAINTENANCE
B1
l a
FRONT OF ENGINE
I
Water inlet tube
Lower intake manifold
1.
Clean the lower intake manifold gasket surface.
2. lnstall the lower intake manifold.
3. lnstall four upper manifold retaining bolts finger tight.
4. lnstall four remaining manifold bolts.
5. Tighten the bolts in the sequence shown in the figure.
Tightening torque:
26-38 N.m (2.6-3.8 kgf.m, 19--28 ftalbf)
5BUOB1-086
Front lifting eye
lnstall the front lifting eye.
Tightening torque:
20-30 N-rn (2.1-3.0 kgf.m, 15--22 ft-lbf}
5BUOB1-015
Exhaust manifold
Clean exhaust manifold bolts and/or stud bolts. Tighten
the bolts in two steps.
Tightening torque:
Step 1: 20-30 N-m (2.1-3.0 kgfem, 15-22 ft-lbf)
Step 2: 60-430 N.m (6.1-4.1 kgfsm, 45-59 ft-lbf)
Timing belt tensioner
Refer to page 81 -63.
Timing belt outer cover
lnstall the timing belt outer cover
Tightening torque:
8-12 N-m (0.8-1.1 kgf.m, 6-43 ft-lbf)
I
I
MB1330-B 5EIUOB1-016
DPF EGR sensor
Note
Connect two hoses properly.