To Install The Damper (3.0L); Crankshaft Pulley Installation (3.0L); Clutch And Fan Assembly Installation (3.0L) - Mazda B-Series 1997 Workshop Manual

ASSEMBLY
FRONT CYLINDER
COVER BLOCK
SEALANT
STOP SEALANT BEAD
3 mm (0.12 in)
FROM TIMING CHAIN
CAVITY
Ll-
4 - 6 {0.16-0.24 m & * in]
REAR MAIN
BEARING CAP
FRONT OF ENGINE
0
\
'DAMPER
125--165 N-m,
(12.7-1 6.8 kgf-m,
93--121 ftelbf)
3.Apply a 4.0-6.0mm (0.2 in) bead of sealant to the
junction of the rear main bearing cap and cylinder block
and the junction of the front cover assembly and cylinder
block.
4.
Position the oil pan gasket to the cylinder block and secure
with adhesive.
5. lnstall the oil pan.
6. lnstall the bolts and tighten to specification.
Tightening torque:
10-14 N.m (1 .O-1.4 kgf-m, 7-10 ft.lbf)
Damper
1. Coat the damper sealing surface with clean engine oil.
2.Apply sealant to the keyway of the damper prior to
installation.
3. lnstall the damper using Damper and Front Cover Seal
Installer T82L-6316-A, or equivalent.
4.
lnstall the washer and bolt and tighten.
Tightening torque:
125-1 65 N-m (1 2.7-1 6.8 kgf.m, 93-1 21 ftlbf}
5BUOB2-056
Crankshaft pulley
lnstall the crankshaft pulley.
Tightening torque:
53-70 N-m (5.3-7.0 kgfam, 40-52 ft-lbf)
5BUOB2-057
1 I
MB1352-A
Clutch and fan assembly
I. lnstall the clutch and fan assembly.
2. Tighten the screws to the specified torque.
Tightening torque:
41-135 N.m (4.1-13.6 kgfem, 30-99 ftalbf)
4BUOB2-144