Mazda B-Series 1997 Workshop Manual page 814

ELECTRICAL SYSTEM COMPONENTS
K
ASSEMBLE RETAINER TO GEAR WITH
TABS ON BACK SIDE OF CLIP TOWARD
TEETH ON SPEEDOMETER GEAR
\
SPEEDOMETER GEAR
\ ,
VEHICLE SPEED
SENSOR ASSEMBLY
\
EN
R
BEFORE ASSEMBLY
TO SENSOR ASSEMBLY
i I
NOTE: ELECTRICAL
CONNECTION MUST
BE NEAR TOP
SCREW AND WASHER
2.5 N.m (25 kgf.cm, 22 in4bfl
7. Install a new driven gear on a new vehicle speed sensor.
8. Secure the speedometer driven gear with the retainer.
9.
Install the new vehicle speed sensor in the transmission
(4x2
models) or transfer case
(4x4
models).
10. Tighten the retaining bolt.
Tightening torque:
2.5 N-m (25 kgf-cm, 22 in.lbf)
11.
Connect the vehicle speed sensor electrical connector.
12.
Lower the vehicle.