STARTING SYSTEM
CLUTCH PEDAL POSITION SWITCH (MT)
This system is similar to that of the parWneutral position
switch
on an
AT vehicle. (Refer
to
Section K.)
If the clutch pedal is not depressed during starting, battery
power will not be supplied to the starter and it will not
operate.
4BUOGX-109
Inspection
1.
Disconnect the clutch pedal position switch connector.
2. Connect a circuit tester to the switch.
3. Check for continuity.
4. Replace the switch, if necessary.
Released
1
No
MGI 075-A