Table of Contents
Advertisement
J1
TRANSMISSION
Speedometer drive gear
The speedometer drive gear contains detents into which
the steel drive ball can be installed. The steel drive ball can
be installed into any of the three detents.
4BUOJ1-069
Extension housina
REAR
EXTENSION HOUSING
SEAL REPLACER
T61 L-7657-A
DRAIN
HOLE
--
TO FACE
FORWARD
1.
Install the extension housing.
Tightening torque:
3 2 4 6 N-m ( 3 . 3 4 . 5 kgf.m, 24--33 ft.lbf)
2. Install the extension housing rear oil seal using the Exten-
sion Housing Seal Replacer
T61 L-7657-A,
or equivalent.
Note
Make sure that the oil seal drain hole faces
downward.
Control case
Install the control case.
MJ1132-A
4BUOJ1-070
The extension housing bushing cannot be ser-
viced. If the bushing requires service, the exten-
sion housing must be replaced. (4x2 only)
Tightening torque:
16-22 N.m (1.7-2.2
kgfem, 12-1 6 ft-lbf)
Note
Do not apply sealant to the control case or trans-
mission mating surfaces.
Drain
plug
Install the drain plug.
Tightening torque:
40-58
N.m (4.1-5.7
kgf.m, 3 0 4 2 ft-lbf)
4BUOJ1-072
Advertisement
Table of Contents
Troubleshooting
